BUS TOP Premium
4.2
General symptoms
Symptom
Hatch will not move
After a reset the drive is blocked,
and does not move to the
required position
30
The following table contains a list
of possible general symptoms.
Cause
No voltage
Cover frozen
Drive unit cable not connected
Drive unit defective or reacts too slowly
Distance between magnet and Hall IC
in the control module is too great
Magnet has been lost
Mechanical defect on the drive unit
Control module defective
.
Remedy
Switch on main vehicle switch
Replace the fuse
Check the contacts and repair them if
necessary
Defrost the cover
Ask an authorised workshop to rectify the fault
Ask an authorised workshop to rectify the fault
Ask an authorised workshop to rectify the fault
Ask an authorised workshop to rectify the fault
Ask an authorised workshop to rectify the fault
Ask an authorised workshop to rectify the fault