Operation - Valeo BUS TOP PREMIUM Notice D'utilisation Et D'entretien

BUS TOP Premium

3.1.2 Operation

1. Select the appropriate hatch po-
sition using the ON/OFF switch.
The hatch moves to the select-
ed position using the defined
movement cycle (see Fig. 302).
NOTE
• The cycle times not shown in
Fig. 302 can be found by adding
the individual values. The direc-
tion in which the hatch moves
(indicated by the arrows) must
be taken into account.
• The controlled identifies in-
creased friction losses, exces-
sive roof loads and blockages
and shuts down the system.
• The controller reacts differently
to any difficulties it identifies
depending on the temperature.
• If it identifies that the system is
not moving easily it resets it.
• To manually reset the system
26
after it has been shut down the
voltage supply must be discon-
nected for at least 10 seconds.
• If the movement is not complet-
ed or if the listed cycle times are
exceeded, consult an au-
thorised workshop, which will
find the problem.
2. Set the ON/OFF switch to
"Closed". The hatch moves to
the closed position using the
defined movement cycle (see
Fig. 302).
closed
opened at the rear
opened at the
front and rear
opened at the front
Fig. 302 Movements with nominal
cycle times