Emergency Exit Function / Emergency Release; General; Operation - Valeo BUS TOP PREMIUM Notice D'utilisation Et D'entretien

3.2 Emergency exit
function / Emergency
release

3.2.1 General

CAUTION
Only use the emergency release in
real emergencies.
The emergency exit function can be
initiated by turning the interior emer-
gency release handle clockwise (as
indicated by the arrow) or by pulling
the exterior emergency release
handle. Both these actions will re-
lease the cover from the opening
mechanism so that it can be raised
or swung away. If there is one and it
is connected the emergency re-
lease/lock indicator light (H2) on the
dashboard will be lit if the ignition is
switched on. Depending on the
application this signal may also be
indicated by a buzzer.

3.2.2 Operation

CAUTION
Only use the emergency release in
real emergencies.
NOTE
The exterior handle can only be
used if the optional lock on the
exterior release handle has been
opened.
If there is one and it is connected
the emergency release/lock indi-
cator light (H2) on the dashboard
will be lit if the ignition is switched
on.
1. Turn the interior emergency re-
lease handle through 90° in a
clockwise direction or unlock
the exterior emergency handle
and pull it away from the cover.
BUS TOP Premium
2. Raise the cover off the opening
levers, swing it through 180°
forwards and place it on the roof
of the bus at the rear.
3. Insert the cover after it has the
emergency release has been
used (see 5.4).
27