Charging 5 V Devices; Troubleshooting - SilverCrest SBTF 10 C2 Mode D'emploi

Charging 5 V Devices

Check the max. input voltage (5V) and the max. power
input (1000 mA) of the device which you want to charge.
For this, consult the operating manual of the device.
Connect the device to be charged with the USB port
on the hands free device. The device now receives its
power supply from the hands free device. If the device
is equipped with a charging indicator light, this will in-
dicate that the device is being charged.
Note:
If the power supply does not activate automatically, you
should disconnect the USB cable from the USB port
and re-connect it.

Troubleshooting

If you cannot connect the hands-free appliance with a
compatible mobile telephone, proceed as follows:
Ensure that the Bluetooth
telephone is activated.
Is the display flashing? Ensure that the hands-free ap-
pliance is correctly installed, switched on and supplied
with electricity.
If you use several Bluetooth
a previously created Bluetooth
mobile telephone is separated. This may indicate that
a previously paired device is in range.
Ensure that the hands-free appliance is distanced a ma-
ximum of 10 metres from the mobile telephone and that
there are no barriers or electronic devices between them.
SBTF 10 C2
function in the mobile
®
appliances, ensure that
®
connection of the
®
GB
IE
13