Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
There are several ways to install the inlet air pipe. We have shown four examples below.
See more variations at www.cinderellaeco.com
If you require a different design for your inlet air system, please contact your nearest sales outlet or service center.
Inlet Air through a Wall Vent
(NOT RECOMMENDED)
If you prefer not to draw in air directly to the toilet, you must make sure that
there is sufficient air flow into the toilet room. The air inlet vent should be
installed as close to the toilet as possible; see fig.14.
•
The vent must be a properly dimensioned intake air vent with at least
⁄
6
in. (160 mm) diameter/31 square inches (201 cm
5
16
•
The vent must be open at all times. Remember to clean the vent at
regular intervals.
•
It is important to ensure that there is no conflict between the requirement
for air supply to the toilet and the requirements of any other installations,
such as a fireplace or kitchen fan.
•
The use of open windows/doors is not a good solution because these
openings will be opened and closed due to other requirements.
•
Do not use a separate ventilation fan to extract air from the room where
the toilet is installed.
NOTE:
If an adjustable vent has been installed in the wall, the vent must
always be open while the toilet fan is running. No obstacles (foam rubber etc.)
hindering the free flow of air must be placed in the vent.
10
) flow area.
2
fig. 14
Publicité
Table des Matières
