8. Installation and connection
8.1 Installation
The code lock is suitable for outdoor use (IP65).
The connection cables must not be kinked or squashed. This can result in mal-
functions, short circuits and defects in the device.
Make sure that cables or wires are not damaged when drilling or bolting in place.
•
Detach the housing cover on the back of the code lock by removing the screw on the under-
side of the housing. A corresponding tool is supplied with the device.
•
There are four round markings on the inside of the housing cover. Make corresponding drill
holes using a 3.5-4 mm metal drill bit.
•
Another hole for the connection cable (depending on diameter) must be drilled into the
centre of the housing.
•
Attach the code lock with suitable installation material to an even, vertical and vibration- free
surface.
23