Solar Priority (If Applicable); Assign Jva; Assign Hotkeys - Zodiac AquaLink Z4 Manuel D'installation

7.9

Solar Priority (if applicable)

INSTALL SETTINGS>SOLAR PRIORITY
NOTE: You will only see this option if solar heating is
installed in your system.
Enable the system to use solar heat first, when available.
If solar heat is no longer available, the system will
automatically switch to the alternate heat source.
INSTALL SETTINGS
Color Lights >
Label Aux >
Temp Calibrate >
Solar Priority >

Assign JVA

>
>
More
• When solar and heater are enabled the solar will
heat the water until either the thermostat setting has
been reached or solar heat is no longer available.
• If the solar panel is not hot enough, solar heat will
shut off and the other heat source (usually gas
heater) will take over to bring the water up to the
thermostat setting.
7.10 Assign JVA
INSTALL SETTINGS>ASSIGN JVA
NOTE: If the system is a pool/spa combination, without
solar, only the solar JVA is assignable. If the
system is a pool or spa only system, without
solar, all three JVAs are assignable. The
example shown is for a pool or spa only system
without solar.
Allow Jandy Valve Actuators (JVAs) to be assigned
®
to any auxiliary on the AquaLink Z4 controller, so
that when you select this auxiliary, the valve turns.
Assigning JVAs lets the pool owner control certain
features like diverting water to a waterfall or bank of
spa jets. Multiple JVAs can be assigned to one auxiliary
without extra hardware.
AquaLink Z4 Controller
®
INSTALL SETTINGS
Color Lights >
Label Aux >
Temp Calibrate >
Solar Priority >
Assign JVA >
>
More
SOLAR PRIORITY
Enable
 Disable
INSTALL SETTINGS

Assign Hotkeys


|
Installation Manual
ASSIGN JVA
INSTALL SETTINGS
Intake Free
Color Lights >
Return Free
Label Aux >
Solar Free
Temp Calibrate >
Solar Priority >
Assign JVA >
>
More
ASSIGN JVA
Intake/Return/Solar
None
Aux1
Aux2
Aux3
7.11 Assign Hotkeys
INSTALL SETTINGS>ASSIGN HOTKEYS
NOTE: You will only see this option if the AquaPalm™
is installed in your system and is turned on.
Assign buttons 1 and 2 on the AquaPalm handheld
remote to any piece of equipment connected to a circuit
or relay for immediate and dedicated control of that
equipment.
INSTALL SETTINGS
INSTALL SETTINGS
>
Assign Hotkeys >
Assign Hotkeys >
Hotkey 1
Hotkey 1
Hotkey 1
Aux1

Aux1
Aux1

Aux2
Aux2
Aux2
Aux3
Aux3
Aux3
Filter Pump
Filter Pump
Pool Heat Filter Pump
Solar Heat
Pool Heat
Pool Heat
Solar Heat
Solar Heat
ENGLISH
Page 19
ASSIGN JVA
Intake Free
Return Free
Solar Free
ASSIGN JVA
Intake/Return/Solar
None
Aux1
Aux2
Aux3
Assign Hotkeys
Assign Hotkeys
Assign Hotkeys
1 Aux1
1 Aux1
2 Aux2 2 Aux2
1 Aux1
2 Aux2