Install Jandy Valve ® Actuators (Jvas) (If Applicable); Basic Navigation - Zodiac AquaLink Z4 Manuel D'installation

Masquer les pouces Voir aussi pour AquaLink Z4:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
Page 12
Red 4-Pin Terminal Bar
Figure 5.
RS-485 Wiring
NOTE: Wire only two (2) devices (e.g, the iAquaLink
and one additional device) to the RS-485
connector. If you have more than one additional
device in your equipment configuration, use a
multiplex board.
5.3
Install Jandy Valve
(if applicable)
You may wire up to three JVAs on the AquaLink Z4.
Two (2) JVAs are included in PSi and PS (Pool/Spa
combo) kits. An additional JVA may be required on a
pool/spa combination configuration to control a water
feature or solar panel, for example.
NOTE: Read and follow complete installation intructions
and safety information in the Jandy Valve
Actuator owner's manual (included in the JVA
packaging).
1.
Install intake JVA and return JVA on equipment
lines according to installation instructions in the
owner's manual.
2.
Feed intake JVA wire through the black low
voltage wiring knockout.
3.
Plug JVAs in as shown in Figure 2. Wiring
Diagram.
4.
Feed return JVA wire through the black low
voltage wiring knockout.
5.
Plug return JCA connection into the center socket.
AquaLink
Z4 Controller | Installation Manual
®
4 Green
3 Yellow
2 Black
1 Red
Actuators (JVAs)
®
More
Section 6.
System Setup,
Programming and Testing
All system programming and installation setup is
performed through the AquaLink Z4 user interface UI.
NOTE: For a complete list of all menu commands and
functions, refer to the Owner's Manual.
Menu Screen
Pool Mode
Pool Heater
Spa Mode
Spa Heater
Settings
Devices
Service Mode
Back
More
Back Button
Power
Power Light
Figure 6. User Interface
6.1

Basic Navigation

Use the following buttons on the user interface to access
and select all menus and commands:
More
On/Off
More
Turn user interface power on/off.
Up/Down
Scroll up/down within current menu to
®
highlight a specific menu command.
Back
Go back to previous menu. To return to Main
®
menu, press Back button repeatedly.
Select
Select current highlighted menu command.
Display the next menu or activate the
selected function.
®
More
Zodiac
12:40PM
O
74°F
O
O
>
>
Up/Down (Scroll)
>
Arrows
Select
Select Button
Alert
Alert Light
Power Button
®

Publicité

Table des Matières
loading

Table des Matières