Storage; Troubleshooting - Barista CM1025AE-GS Mode D'emploi

1. Clean the permanent fi lter (13), the fi lter insert (12) and the glass jug (9) after every
use with mild detergent and warm water or in the dishwasher.
2. If necessary, wipe down the coffee bean compartment (3) and the lid (1) with a damp
cloth.
3. Wipe down the housing with a damp cloth. If necessary, use a little mild detergent to
remove more intense soiling.
4. Check the mains cable regularly for any damage.
Descaling
If the water only runs very slowly through the device or the device is louder than usual
during the brewing process, it needs to be descaled. Use a standard descaling agent for
coffee machines to do this.
1. Pour a mixture of water and descaling agent into the water tank and switch on the
device (without any coffee powder). Consult the instructions for using the descaling
agent with regard to the ratio of water to descaling agent.
2. Allow all of the mixture to run through and repeat this process if necessary if the water
still runs through slowly.
3. After descaling, let water (without coffee powder) run through the device at least
three times to fl ush the lines, etc.

Storage

Disconnect the device from the mains power when it is not going to be used for a pro-
longed period. Clean the device again if necessary (see the "Cleaning and Care" chap-
ter) and let it dry completely.
Store the device and all accessories in a dry, clean, frost-free place that is protected from
direct sunlight and cannot be accessed by children or animals.

Troubleshooting

If the device does not work properly, check whether you are able to rectify the problem
yourself. If the problem cannot be solved with the steps that are listed, contact the cus-
tomer service department.
Do not attempt to repair a defective electrical device yourself!
Problem
Nothing is shown on
the display (14).
29
Possible cause
The mains plug is not in-
serted correctly in the plug
socket.
The plug socket is defective.
No mains voltage is present.
The display is defective.
Fix
Insert the mains plug.
Try another plug
socket.
Check the fuse of the mains
connection.
Contact our customer service
department.
EN