Barista CM1025AE-GS Mode D'emploi page 21

■ Be careful when removing the fi lter insert after operating the device. There may
still be hot water remaining in / on the fi lter insert or permanent fi lter! Always al-
low the fi lter insert and the permanent fi lter to cool down fi rst before they are
removed / cleaned.
■ Never pour water into the water tank when the device is switched on or during the
brewing process. Allow the device to cool down before fi lling it again.
■ Do not move the device during the brewing process.
■ The coffee which is prepared is hot! Be careful when handling hot liquids.
■ Keep items of clothing such as scarves, shawls, jewellery, ties and long hair away
from the coffee bean compartment and the grinder shaft.
■ Do not reach into the coffee bean compartment and the grinder shaft and do not
insert any objects when the device is in operation!
■ Make sure that the connected mains cable does not present a trip hazard. The mains
cable must not hang down from the surface on which the device is placed in order to
prevent the device from being pulled down.
■ Do not use the coffee jug if its handle is loose or damaged.
WARNING – Danger of Fire
■ Do not use the device in rooms containing easily ignitable dust or poisonous and
explosive fumes.
■ Do not connect the device along with other consumers (with a high wattage) to a mul-
tiple socket in order to prevent overloading and a possible short circuit (fi re).
■ Do not operate the device in the vicinity of combustible material. Do not place any
combustible materials (e.g. cardboard, paper, wood or plastic) in or on the device.
■ Do not cover the device during operation.
■ In the event of a fi re: Do not extinguish with water! Smother the fl ames with a fi reproof
blanket or a suitable fi re extinguisher.
NOTE – Risk of Damage to Material and Property
■ The device should only be used if it has been correctly assembled! Before each use,
check whether the fi lter insert and the permanent fi lter are inserted correctly and
whether the water tank is fi lled correctly!
■ Lay the mains cable in such a way that it does not become squashed or bent and
does not come into contact with hot surfaces (also applies to the hot surfaces of the
device!).
■ Switch off the device and pull the mains plug out of the plug socket if an error occurs
during operation, when there is a power cut or before a thunderstorm.
■ Never pull or carry the device by the mains cable. When you pull it out of the plug
socket, always pull on the mains plug and never the mains cable!
■ Protect the device from other heat sources, naked fl ames, sub-zero temperatures,
persistent moisture, wet conditions and impacts.
■ Use only original spare parts from the manufacturer.
21 EN