Technical Data; Disposal - Barista CM1025AE-GS Mode D'emploi

Problem
The coffee is too
weak.
Timer function: The
device does not start
at the set time.
A large amount of
steam is produced in
the brewing process.
During use, an
unpleasant smell is
detected.

Technical Data

Model number: CM1025AE-GS
Article number: 04289
Voltage supply: 220 – 240 V~ 50 Hz
Power: 900 W
Protection class: I
Fill volume: max. 1.5 l

Disposal

The packaging material is recyclable. Dispose of the packaging in an environ-
mentally friendly manner and take it to a recycling centre.
Dispose of the device in an environmentally friendly manner. It should not be
disposed of in the normal household waste. Dispose of it at a recycling centre
for used electrical and electronic devices. More information is available from
your local authorities.
31
Possible cause
There is too much water in
the water tank.
There is too little coffee in the
permanent fi lter.
The timer function hast not
been activated?
The device is furred up.
Is the device being used for
the fi rst time?
Has the device just been
descaled?
Fix
Only pour the quantity of
water required for the number
of cups you want into the
water tank.
Fill the quantity of coffee be-
ans or powder for the number
of cups you want into coffee
bean compartment or the
permantent fi lter.
Activate the timer function
(see the „Preparation" – „Ma-
king coffee with a preset
time" chapter).
Descale the device (see the
"Cleaning and Care" chapter |
"Descaling").
A smell often develops when
new devices are fi rst used.
The smell should disappear
once the device has been
used several times.
Rinse out the device with
clear water.
Customer Service / Importer:
DS Produkte GmbH
Am Heisterbusch 1
19258 Gallin
Germany
Tel.: +49 38851 314650
(Calls to German landlines are
subject to charges. The cost varies
depending on the service provider.)
All rights reserved.
EN