Unit Configuration - Oase Profi Clear Premium Compact L Notice D'emploi

3.4

Unit configuration

 E Pump fed
1
2
3
4
—
6
7
8
9
10
11
12
13
14
15
16
17
18
—
20
21
22
23
24
25
—
27
28
29
30
31
32
33
34
35
36
 F Gravity fed Description
1 Container cover
2 Signal box with level detection device (3) and temperature probe (7)
• The signal box is connected to the control system (30, 32)
3 Level detection device
• Signals the water level in the filter system
4 Rollers for guiding the filter drum
5 Pump status detection
• Signals a pump failure
6 Filter drum with 8 screen elements
• Screen elements for coarse dirt down to 60 µm in size, optionally available
for 30 + 150 µm
7 Temperature probe
• monitors the water temperature
8 Air hose 9 mm
9 Hel-X 13 biomedia in Moving Bed filter chamber
10 2 × outlet DN 110
11 Aerator rod
12 Meshed tube
• Prevents theHel-X biomedia from being flushed out
13 Rinsing pump for supplying the rinsing device (24)
14 1 x dirt outlet DN 75 with slide valve
— 2 × adapters, 2 × 30° inlet bend with union nut for connection of the UVC
clarifier Bitron to 38 mm (1½ ") connections (18)
— Connection set for filter pumps
• 1 × 50 mm (2 ") hose connector, 1 × union nut for hose connector, 1 × 40
... 60 mm hose clip, 1 × flat seal (2 ") 56 mm × 43 mm × 3 mm
— 1 × inlet 50 mm (2 ")
• For connecting a filter pump
— 2 × 38 mm (1½ ") inlet, closed with sealing plugs
• For connecting an optional UVC clarifier Bitron
19 3 × inlet DN 110 with cover cap
20 1 × optional inlet DN 110
• Must be cut out, if required (connection not included in the scope of
delivery)
21 1 × coarse dirt outlet DN 110
22 Drum motor for filter drum
• the motor is connected to the control system (30, 31)
23 Dirt channel
• Collects the coarse dirt and rinsing water from the screen elements (6)
24 Rinsing device
• Sprays water at high pressure onto the screen elements (6) to rinse off the
coarse dirt
25 Grease for the drum seal
26 2 × ground stakes for installing the control system
27 9/4 mm transition piece
28 Y piece
29 2 × cable binders for fastening the air hoses to the Y piece
30 Control system with EGC box
• Allows integration with cables into an EGC network.
31 Connector for drum motor
32 Connector for signal box
33 Mains connection cable
34 Connector for rinsing pump
35 Fuse holder
• Fuse protection of the control system with 5 × 20 mm, T8 A 250 V safety
fuse
36 2 × caps, cap nuts for fixing the EGC box
• Required for mounting the EGC box on the container wall
- EN -
51