Connecting An Additional Egc Compatible Unit; Installing The Control System With Egc Box; Pump Fed System; Gravity Fed System - Oase Profi Clear Premium Compact L Notice D'emploi

- EN -
4.4.3

Connecting an additional EGC compatible unit

An additional EGC compatible unit can be connected to the EGC box.
► Ensure the correct connection.
How to proceed:
 N, O
1. Remove the protection cap from EGC-OUT on the EGC box and fit the plug connector of the
EGCConnection Cable.
2. Remove the protection cap from EGC-IN on the additional unit and fit the other plug connector of the
EGC Connection Cable.
3. Remove the protection cap from EGC-OUT on the additional unit and fit the terminal resistor or
connect an additional EGC unit.
4.5

Installing the control system with EGC box

4.5.1

Pump fed system

► Install the control system at a minimum distance of 2 m from the pond.
► Protect the control system from direct sun radiation.
► The control system is splash-proof and may be exposed to rain.
How to proceed:
 L
1. Either attach the control system and EGC box to the container wall or use threaded hooks to mount it
in different position.
2. If the EGC box is attached to the container wall, fit both caps onto the cap nuts.
– The caps fix the EGC box in place.
4.5.2

Gravity fed system

 L
► Install the control system at a minimum distance of 2 m from the pond.
► Protect the control system from direct sun radiation.
► The control system is splash-proof and may be exposed to rain.
► Push both ground stakes onto the control system and push the ground stakes into the ground.
N O T E
If the ground is hard:
► Protect the control system from knocks/impact.
► Push both ground stakes onto the control system.
► With light pressure push the ground stakes into the ground to mark the position.
► Detach the ground stakes from the control system and drive them into the ground.
Then push the control system onto the stakes.
58