Haier AC35S2SG1FA Mode D'emploi page 23

installation Procedure
Please ask the dealer or specialist to install, never try by the users themselves. After the installation please be sure of the following
conditions.
WARNING
y Please call dealer to install the air-conditioner. Incorrect installation may cause water leaking, shock and fire hazard.
CAUTION
y Air-conditioner can't be installed in the environment with inflammable gases because the inflammable gases near air-
conditioner may cause fire hazard.
y Installed electrical-leaking circuit breaker.
It easily cause electrical shock without circuit breaker.
y Connect earthing wire.
Earthing wire should not be connected to the gas pipe, water pipe, lightning rod or phone line, incorrect earthing may cause
shock.
y Use discharge pipe correctly to ensure efficient discharge.
Incorrect pipe use may cause water leaking.
y Wiring
Air-conditioner should be equipped with special power supply wire.
y Location
y Air-conditioner should be located in well-vented and easily accessible place.
y Air-conditioner should not be located in the following places:
(1) Places with machine oils or other oil vapours.
(2) Seaside with high salt content in the air.
(3) Near hot spring with high content of sulfide gases.
(4) Area with frequent fluctuation of voltage e.g. factory, etc.
(5) In vehicles or ships.
(6) Kitchen with heavy oil vapour or humidity.
(7) Near the machine emitting electric-magnetic waves.
(8) Places with acid, alkali vapour.
y Choose the following locations:
(1) Capable of supporting air conditioner weight. Don't increase operating noise and vibration.
(2) Hot vapour from outdoor unit outlet and operating noise don't disturb neighbour.
(3) No obstacles around the outdoor unit outlet.
y TV, radio, acoustic appliances etc. are at least 1 m far away from the indoor unit, outdoor unit, power supply wire, connecting
wire, pipes, otherwise images may be disturbed or noises be created.
y As required, take measures against heavy snow.
For authorized sevice personnel only
WARNING
(1) For the room air conditioner to operate satisfactorily, install it as outlined in this installation manual.
(2) Connect the indoor unit and outdoor unit with the room air conditioner piping and cords available from our standard parts. This
installation manual describes for the correct connections so that the installation set available from our standard parts should be
used.
(3) Installation work must be performed in accordance with national wiring standards by authorized personnel only.
(4) Never cut the power cord, lengthen or shorten the cord, or change the plug. Do not use an extension cord.
(5) Plug in the power cord plug firmly. If the receptacle is loose, repair it before using the room air conditioner.
(6) Do not turn on the power until all installation work is done.
CAUTION
(1) Be careful not to scratch the room air conditioner when handing it.
(2) After installation, explain correct operation to the customer, according to the operating manual.
(3) Let the customer keep this installation manual because it will be used when the room air conditioner is serviced or moved.
21
Earthing