Remedy Of Faults; Wear Parts; Maintenance And Cleaning - Oase Waterfall Illumination 30 Notice D'emploi

Function description
Waterfall Illumination allows the illumination of a suitably dimensioned artificial waterfall at its source with a warm
white light.
Intended use
Waterfall Illumination, referred to as "unit", may only be used as specified in the following:
• Only operate with water at a water temperature of +4 °C to +35 °C.
• Operate in accordance with instructions.
Installation
N O T E
Sensitive electrical components. Incorrect connection will destroy the unit.
• Do not connect the unit to a dimmable power supply.
How to proceed:
 B, C
1. Plug the holders onto the light rail.
– Do not mix up the right and the left holder.
2. Place the light rail into the source bed of the waterfall from above. Ensure that the holders are correctly placed in the
source bed.
3. Install the transformer at a minimum safety distance of 2 m from the water.
4. Connect the connection cord of the unit to the safety transformer.
Commissioning/start-up
Switching on the unit: Plug the power plug of the transformer into the socket. The unit switches on immediately.
Switching off the unit: Disconnect the transformer power plug.

Remedy of faults

Malfunction
LEDs are not lit

Wear parts

• Bulb

Maintenance and cleaning

W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
• Isolate the device (disconnect from the power supply) before carrying out any work on it.
• Ensure that no moisture can enter the unit.
Cleaning the unit
If necessary, clean the unit with clear water using a soft sponge or cloth.
Cause
No mains voltage
Supply cable defective
Transformer defective
Light rail defective
Remedy
Check mains voltage
Check supply lines
Replace the attendant unit
Replace transformer
Replace unit
- EN -
9