Remedy Of Faults; Protective Measures - Oase LunAqua Terra Notice D'emploi

- GB -
Operation
Attention! Sensitive electrical components.
Possible consequence: The unit will be destroyed.
Protective measure: Do not connect the unit to a dimmable power supply.
Note!
Note the following points to ensure the LED's maximum operating life:
• Avoid operating the lamps under direct sun radiation and at ambient temperatures above 45° C.
• Control the lamps using a timer or a photo-electric switch. Adhere to the instructions for use of the individ-
ual additional device!
Switching on: Connect plug-in transformer to the socket. The unit switches on immediately when the power connec-
tion is established.
Switching off: Disconnect the plug-in transformer.

Remedy of faults

Malfunction
None of the lamps is lit
One of the lamps is not lit
Cleaning
Attention! Dangerous electrical voltage.
Possible consequences: Death or serious injuries.

Protective measures:

Prior to reaching into the water, disconnect the power supply to all units used in the water.
•
Disconnect the unit from the plug-in transformer prior to starting any work.
•
Secure the unit to prevent unintentional switching on.
•
Clean the lamp screen occasionally using a moist cloth.
The lamp housing made of corrosion-resistant stainless steel may show initial easily removable rust. Remove the rust
using a suitable cleaning agent.
Disposal
Support us in our endeavour to keep our environment intact, and adhere to the following disposal information!
Use our return system for disposal. Always make electrical
units unusable by cutting the cables!
Lamp
Connector
Plug-in transformer
10
Cause
Plug-in transformer not connected
Power supply interrupted
Plug-in transformer has switched off as a result
of excessive ambient temperature
Plug-in transformer is defective
Connector is defective
Power supply interrupted
Connector corroded
Bulb defective
Defective output at the connector
Disposal with the household waste:
Packaging
Remedy
Connect plug-in transformer to the socket.
Check power supply
Allow the plug-in transformer to cool down,
select a different location
Replace the plug-in transformer
Replace the connector
Check connection cable. Replace lamp if de-
fective
Clean connector
Replace lamps
Replace the connector