Panasonic TY-WK65PR20 Manuel D'installation page 16

Fitting procedure
Tighten up the screws for securing unit
Note
• Tightening up the screws for securing unit
Lift the plasma display slightly, and check that it is firmly secured in place.
Horizontal installation
Screw for securing unit
(Tightening torque: 1.2 to 1.5 N•m)
Removing the plasma display
Place a soft blanket or piece of cloth underneath the plasma display.
Otherwise, the screws for securing unit
leaving marks on the surface of the floor.
Remove the screws for securing unit
of the wall-hanging bracket.
Horizontal installation Left and right side of wall-hanging bracket
Vertical installation Top and bottom of the left side of the wall-
Disconnect the power cord and the wires connecting the plasma
display to the other units.
While lifting the bottom part of the plasma display, pull the plasma
display toward you.
After the bottom insulation spacers have been removed, continue
lifting up the plasma display and remove it.
Note
• The plasma display needs to be lifted up approximately 4 cm
(1.6 inches) to be removed.
16
, which was secured loosely in section 4, until it will go no further.
too much may cause the bracket to be bent out of shape.
may drop down by mistake,
which is attached to the side
hanging bracket
Vertical installation
Screw for securing unit
(Tightening torque:
1.2 to 1.5 N•m)
Blanket or piece
of cloth
Floor surface
Screw for securing unit
Lower
insulation
spacer