Panasonic TY-WK65PR20 Manuel D'installation page 12

Components
Parts used to assemble the wall-hanging bracket
Base upper and lower
fitting (2)
Parts used for installation
View of fully assembled fixture
L
The images shown in this manual are for illustrative purpose only.
The product specifications may be changed at any time without prior notice.
Precautions for wall-hanging bracket fitting
The wall-hanging bracket is for use in attaching a plasma display unit to a vertical wall for viewing.
Do not fit to any surface other than a vertical wall.
To ensure correct plasma display performance and prevent trouble, do not fit at any of the following locations.
• Near sprinklers or fire/smoke detectors
• Where there is a risk of exposure to vibration or impact
• Near high-voltage wires or dynamic power supplies
• Near sources of magnetism, heat, water vapor or soot
• Locations exposed to air blown from heating equipment
• Where droplets of condensation from an air conditioner or other unit may form
Fit using techniques suited to the structure and materials of the fitting location.
Use commercially available screws with a nominal diameter of 6 mm (0.2 inches) that are suited to the wall
material (wood, steel frame, concrete etc.) you are fitting the bracket to.
Ensure good air flow so that the ambient temperature does not exceed 40 °C (104 °F).
Failure to do this may cause heat to build up inside the plasma display, resulting in malfunction.
Spread a soft blanket or cloth over the floor so that the plasma display and floor will not be marked or scratched
during the assembly and installation work.
When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over tightened.
For the plasma display power supply plug, use a power supply outlet that can be reached easily.
Take sufficient care and ensure safety around you when performing the installation work.
Do not install the plasma display underneath ceiling lamps (spotlights, halogen lamps, etc.).
Otherwise, the cabinet may be bent or damaged by high heat.
To the Installation Contractor
If the wall-hanging bracket installation and display installation work are performed by different contractors, please
ensure that this instruction manual is passed from the wall-hanging bracket installation contractor to the display
installation contractor after the wall-hanging bracket installation work is complete.
Please give this instruction manual to the customer after the installation work is completed.
12
Bracket base left fitting
(1)
Allen head countersunk screw (4)
M8×32
Dished toothed washer (4)
Insulation spacer (4)
R
Bracket base right fitting
(1)
Screw for securing unit (2) M5×100
Allen wrench (included tool) (1)
Screw for assembling
the fixture (8)
M5×10