Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Settings Menu 2

In Settings Menu 2, you can make the following settings.
Illumination
Automatic display backlight off
Automatic power saving function
Volume display
You can also open Settings Menu 3 from this menu.
Illumination
LIGHT>***
You can set whether or not the rings around the INPUT and VOLUME
knobs light.
The default setting is "AUTO".
AUTO
When the knobs are operated, their rings light.
ON
The rings around the knobs will stay lit.
OFF
The rings around the knobs do not light.
Automatic display backlight off
DPaOFF>***
You can set the display backlight to automatically turn off if no opera-
tion is conducted for a certain amount of time.
By default, the setting is ON.
ON
If no operation is conducted for 10 minutes, the display automati-
cally turns off.
OFF
The display will not turn off, but it will dim to the same brightness
as DIMMER1 to protect the display from wear.
o We recommend setting this to "ON" because brightness
irregularities might occur if the same information is shown without
change on the display for a long time.
22
Automatic power saving function
APS>***
o By default, the setting is 30m.
If there is no audio input (continuous silence) from the selected input
source for the set amount of time, the unit will turn off automatically.
o Audio input from input sources other than the one selected
has no effect on the operation of the automatic power saving
function.
30m
30 minutes
60m
60 minutes
90m
90 minutes
120m
120 minutes
OFF
The automatic power saving function is disabled.

Publicité

Table des Matières
loading

Table des Matières