Settings Menu 1 - Esoteric grandioso f1 Mode D'emploi

Settings Menu 1

In Settings Menu 1, you can make settings for the selected input
source.
You can set the output level adjustment, phase inversion and input
source name. You can set these independently for each of the inputs.
Adjusting the output level
LEVEL>***
You can adjust the output level for the selected input.
You can set this to values between −18.0 dB and +18.0 dB in 0.5dB
increments.
The default value is 0.0 dB.
Note about settings and sound quality
The Level (output level adjustment) setting items affect the vol-
ume. This unit's microcomputer analyzes these settings and the
volume level value comprehensively to conduct unified control of
volume amplification.
For this reason, unlike ordinary amplifiers that pass audio signals
through multiple circuits, these settings will not degrade the
audio quality.
Phase inversion
PHASE>***
This switches the phase of the selected input connector.
If the XLR connector of the audio output device is pin 3 HOT, select
INV.
By default, this is set to NOR.
NOR
No phase inversion
When using XLR input connectors, pin 2 is HOT.
INV
Phase inversion enabled
When using XLR input connectors, pin 3 is HOT.
Input source name
XLR1>***
(This appears when the input source is XLR 1.)
You can change the names shown on the display for the unit's con-
nectors when you turn the INPUT knob. You can set the names as you
like (up to five characters).
EDIT
Use to change input source names.
Changing input source names
1 Show "EDIT", and press the MM/MC (phono selection)
button.
You can also press the setting (STANDBY/ON) button on the
remote control.
2 Enter the characters.
The cursor blinks beneath the character being input.
Use the INPUT knob to move the cursor, and use the VOLUME
knob to select characters.
You can also use the remote control INPUT (k/j) buttons to
move the cursor and its VOLUME (+/−) buttons to change the
character.
3 When you have finished input, press the MM/MC (phono
selection) button to confirm the change.
You can also confirm by pressing the setting (STANDBY/ON)
button on the remote control.
o While entering the name, the volume and input connector
cannot be changed.
o Available characters
English letters: A–Z, a–z
Numbers: 0–9
Symbols: ! " # $ % & ' ( ) * + , − . / \ : ; < = > ? @ (blank)
21