Preparation - Westfalia Automotive SIARR 338074600001 Notice De Montage

SIARR
5087

PREPARATION

* Remove the bumper.
* Remove the absorber.
* Take out the trim from the bottom and sides of the boot.
* Inside the boot, take out the 2 plastic plugs that are blocking the holes marked A.
* Make a cut in the bumper (detail 1), as well as in the plastic guard
under the vehicle (detail 2).
ASSEMBLY
* Inside the boot, locate and then drill the 2 x 17,5mm diameter holes
at the points marked X.
* Position then fasten (without tightening) brackets B and C to the rear
of the vehicle using fastening kit W.
* Insert the square washers E into the longitudinals at the points marked Y.
* Inside the boot, line up back plates H and I and spacers V1-X1 with the points
marked V and X ; under the vehicle join towing arms F and G to points X and Y,
fasten the unit together (without tightening) using fastening kits V, X and Y.
* Assemble the tow bar body J and the 2 strengthening pieces K and L
using fastening kits S, T and U.
FINISHING
* Tighten all of the fastenings to the torques indicated below and in the
following order : S-T-U-V-W-X-Y.
* Reassemble all of the components removed during the above procedure.
* Fit the tow ball to the points marked Z.
M16 AC8.8 19,5daNm M12
M16 AC10.9 27,5daNm M10
M12 AC8.8 8,1daNm M10
ASSEMBLY INSTRUCTIONS
TORQUES :
AC10.9 11,4daNm M8 AC8.8
AC8.8 4,7daNm M8 AC10.9
AC10.9 6,7daNm
FILE : BUREAU\NOTICEDEMONTAGE\SIARR\NDMWESTFALIA\NDM5087-B - FOLIO NDM ANG
BLOC VISSERIE
2 off HM10x40 screws
S
2 off CS10 washers
6 off HM8x40 screws
W
6 off CS8 washers
4 off HM10x40 screws
U
4 off CS10 washers
4 off HM10 nuts
2 off HM10x40 screws
Y
2 off CS10 washers
2 square washers (E)
2 off HM12x60 screws
Z
2 off CS12 washers
2 off HM12 nuts
Type Type
Approval No.
Tow-bar for
HONDA e11*94/20*00*5346
Accord
NB : Electrical diagram inside our universal or custom wiring kits.
PLEASE NOTE : (to familiarise yourself with the operating charasteristics refer to the log)
2,3daNm If this tow bar is fitted in accordance with our recommendations it will give a complete-
3,3daNm ly satisfaction. We cannot accept any responsability in the event of changes to or
improper use of this item.
338074600001
2 off HM10x40 screws
T
2 off CS10 washers
2 off HM10 nuts
2 off HM10x60 screws
V
2 off CS10 washers
2 off spacers dia. 15/21
lg.33 (V1)
2 off HM10x100 screws
2 off CS10 washers
X
2 off HM10 nuts
2 off spacers dia. 12/17
lg.69 (X1)
Max. Total Max. Total Max. Verti-
Authori. Weight Towable Weight
cal load
1 970 kg 1 500 kg
Value
D
75 kg 8,35 kN