Preparation - Westfalia Automotive SIARR 304113600001 Notice De Montage

SIARR
01 - 91

PREPARATION

* Remove the gravel flap located under the bumper.
* Remove the terminal nut from the top of the exhaust
pipe and make a cut as per sketch no.2.
ASSEMBLY
* Under the longitudinals, at the points marked X, fasten, without
tightening, arms A and B, using fastening kits X.
* Fasten arms A and B to the points marked U using fastening kit U.
* Fasten the tow bar body C to the points marked W using fastening kit W.
* Fasten the head E to the two bar body C at the points marked Y
using fastening kit Y.
* Fasten the tow ball D to the points marked Z using fastening kit Z.
FINISHING
* Tighten all of the nuts, bolts and screws to the torques indicated below.
* On the gravel flap, trace, then cut out the holes as per scetch no.1.
* Refit the gravel flap.
FASTENING KIT
4 off HM10x30 screws
W
4 off CS10 washers
4 off HM10x35 screws
X
4 off 10/25 plain washers
4 off CS10 washers
2 off HM10x35 screws
U
2 off 10/27 plain washers
2 off CS10 washers
2 off HM16x45 screws
Z
2 off HM16 nuts
2 off DEC16 washers
M16 AC8.8 19,5daNm M12
M16 AC10.9 27,5daNm M10
M12 AC8.8 8,1daNm M10
ASSEMBLY INSTRUCTIONS
!
2 off HM12x90 screws
Y
2 off HM12 nuts
2 off CS12 washers
TORQUES :
AC10.9 11,4daNm M8 AC8.8
AC8.8 4,7daNm M8 AC10.9
AC10.9 6,7daNm
FILE : BUREAU\NOTICEDEMONTAGE\SIARR\NDMWESTFALIA\NDM0191-C - FOLIO NDMANG
Affix the sticker in the position
!
indicated
NB :
Connecting a universal wiring kit ref.8526 is absolutely impossible on the vehicle (may
cause damage).
It is essential to use either a dedicated wiring kit or a relay box ref.8530.
Type Type
Approval No.
Tow bar for
Citroën C5 Ph.2 e11*94/20*00*5576
(Standard)
NB : Electrical diagram inside our universal or custom wiring kits.
PLEASE NOTE : (to familiarise yourself with the operating charasteristics refer to the log)
2,3daNm If this tow bar is fitted in accordance with our recommendations it will give a complete-
3,3daNm ly satisfaction. We cannot accept any responsability in the event of changes to or
improper use of this item.
Cut-out for
tow ball
Cut-out for
electrical plug
support
Max. Total Max. Total
Authori. Weight Towable Weight
2 010 kg 1 800 kg
304113600001
Sketch n°1
Cut-out for
right arm
Sketch n°2
Max. Verti- Value
cal load D
75 kg 9,32 kN