Cleaning And Sanitizing Instructions - Waring Commercial MX1300XTEE Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

• Never stand directly over blender when it is being started or while it

is running.

NOTE: The MX1300XTEE/EK does not include a Sound Enclosure.

Your MX1500XTSEE/SEK is equipped with a heavy-duty polycarbonate

sound enclosure to reduce noise level while blending. This sound enclosure

is removable and dishwasher safe.

To remove the sound enclosure, follow these steps:

1. Open sound enclosure and remove blender container.

. Remove rubber jar pad.

3. Remove 3 screws from blender base and remove sound enclosure.

NOTE: To replace sound enclosure, follow above steps in reverse.

Whether your blender is in standby mode, new programming mode, or the

motor is running, pressing the STANDBY

running and will turn the power off.

NOTE: All programs and current settings will be restored next time you turn

unit on.

THE BLENDER CONTAINER MUST BE CLEANED AND DRIED AFTER EACH

USE ACCORDING TO THE FOLLOWING INSTRUCTIONS. FAILURE TO DO

SO MAY ALLOW RESIDUES OF PROCESSED MATERIAL TO COLLECT ON

THE INTERNAL SEALS OF THE BLADE ASSEMBLY, RENDERING THEM

INEFFECTIVE.

• Wash, rinse, sanitize and dry container prior to initial use and whenever it

will not be used again within a period of 1 hour.

• Wash and rinse container after each use.

• Clean and sanitize motor base prior to initial use and after each use.

• Washing solutions based on non-sudsing detergents and chlorine-based

sanitizing solutions having a minimum chlorine concentration of 100 PPM

are recommended.

The following washing, rinsing, and sanitizing solutions or their equivalents

may be used.

SOLUTION

Washing

Diversol BX/a or CX/A

Rinsing

Sanitizing

SOUND ENCLOSURE

TURNING OFF YOUR BLENDER