Waring Commercial MX1300XTEE Mode D'emploi page 3

MX1300XTEE/MX1500XTSEE CONTROL PANEL
7
3
1. Standby Button – Pressing this button will power the blender on and
off. When the unit is powered on, the blue LCD backlight will illuminate
and will prompt user when the machine is ready for blending.
2. Start/Stop Button – Pressing this button once while in standby mode
will start the blender. Pressing this button again will stop the blender.
NOTE: The blender should not be run without a container or with an
empty container.
3. Speed Controls – Gradually increase and decrease the blending speed
in 1% increments. The speeds range from 15% to 100%. The Speed
Controls can also set the speed of the NORM Pulse function.
NOTE: Speed settings will be saved when unit is turned off.
4. Maximum Pulse Control – Pressing this button provides a quick burst
of speed during a blending cycle. The MAX Pulse button will run the
blender at 150% power (30,000 RPMs).
5. Normal Pulse Control – Pressing this button provides a quick burst of
speed during blending cycles at speeds of less than 100%. The NORM
PULSE button will run the blender at 100% power (0,000 RPMs).
6. LCD Display – This window will display all operating messages with a
sharp, blue LCD backlight.
7. Program Buttons for Pre-set Reprogrammable Beverage Stations –
These blenders are equipped with 4 preprogrammed beverage stations.
These stations consist of the most frequently blended drinks. All stations
are reprogrammable to accommodate the preferences of all users.
See pages 5 to 6 for details on this feature.

3
6
1
4
5