System Communication - Gree GMV-680WM/E-X Manuel D'utilisateur

Power cord and communication wire should be separated, with a distance of more than
20cm. Otherwise, system's communication may not work well.
(5) Steps of power cord connection:
1) Knock off the cross-through opening that's used for leading the external power cord,
with the cross-through rubber ring on the opening. Then lead the cable through the
opening. Connect L1, L2, L3, N of power cord and ground wire separately to the
positions on wiring board (for power supply) that are marked with L1, L2, L3, N and the
ground screw nearby.
2) Fasten the power cord with cable tie.
3) Lay the power cable and communication cable for the ODU according to the marker of
external connection circuit diagram.

4.6 System Communication

4.6.1 Communication system include:
(1) Communication among outdoor basic modules;
(2) Communication between ODU and IDU;
(3) Communication among IDUs;
(4) Communication between IDU and wired controller;
(5) Connection between IDU and light board receiver;
(6) Communication between different refrigeration systems;
(7) Graphics of general communication connection
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
38
GMV DC Inverter VRF