Vuly Thunder Manuel page 16

5.0 Installation
STEP 10
A.
Insert one Lower Net Pole (5) into the Joiner to the left of the
trampoline entrance.
B.
Find the circular hole in the Skirt (12) that it is to the left the
large, square foot hole. Slide it over the Lower Net Pole.
REMEMBER: Ensure that the foot hole in the Skirt is to the right of
the Lower Net Pole – where the entrance will be when you
re-erect your Safety Enclosure.
STEP 11
Go around your trampoline, pulling the Skirt so that it covers
the Leaf Springs. Ensure that each hole lines up with
the corresponding Joiner Pole as you go.
STEP 12
Remove the Lower Net Pole.
30 | Vuly Thunder
5.0 Installation
STEP 13
A.
Insert each Upper Net Pole (2) into each Lower Net Pole (5).
The Lower Net Pole is reinforced at the bottom.
B.
Rest the completed Net Poles against the frame at
each Joiner Pole.
NOTE: Your model will have safety sleeves on the Lower Net Poles.
Do not remove these safety sleeves! Ensure that they are at the
top of your Lower Net Poles when you insert the Upper Net Poles.
STEP 14
Insert each Nut Pole plug into every Upper Net Pole.
Remember: Do not work in circles but always connect
the opposite plug.
Ensure that the materials are not twisted and that the top holes on
the Upper Net Poles are facing outwards.
STEP 15
A. Lift a Net Pole, raising the Safety Net at the same time, and
insert it into the Joiner Pole.
B. Repeat for each Net Pole until you have completely erected
the Safety Net.
REMEMBER: Ensure that the Safety Net is correctly assembled.
A properly installed Safety Net is crucial to protect against injuries.
WARNING: Make sure that all push buttons are locked and secured
before using your trampoline. Bouncing on a trampoline with push
buttons that are not locked will cause damage and injury.
CONGRATULATIONS !
You have assembled your VULY Thunder trampoline!
Vuly Thunder | 31