Viatom Checkme Pro Manuel De L'utilisateur page 20

The SpO sensor may cause skin sensitivity to the patient. Changing another finger

2
if you feel uncomfortable.
Before using as a sleep monitor, please ensure the battery is fully charged.

To start a sleep monitor measurement,
1. Tie the wristband on one of your left hand.
2. Insert the SpO
connector.
3. Put one of your finger into the sensor. Forefinger or
middle finger is suggested. If needed, remove the
colored nail polish from the finger. Make sure that the
sensor is correctly placed so that the cable goes above
your hand back.
4. Press the Home button to enter the Main Screen. Then Tap the Sleep Monitor icon
to enter the screen as below.
5. Tap the
timer is always displayed at the lower left part.
6. You can press Home button to lock the screen, as shown below. The device will
work in a very low power consumption mode.
7. Insert the device into the wrist band cover, and then begin to sleep.
8. When you get up, or when you want to stop monitoring, you can press the Home
button again to unlock the screen, and then tap
9. You can tap
button and return to the Main Screen.
4.9 Pedometer
To start a Pedometer measurement,
1. In the Main Screen, select <Pedometer> to enter <Choose User> screen. If you
cable into the multi-functional
2
button to start the sleep monitoring. During monitoring, a countdown
button to view the SpO
icon to stop sleep monitoring.
trending during your sleep, or tap "Close"
2
19