Viatom Checkme Pro Manuel De L'utilisateur page 14

3. The display will then show your ECG waveform.
The device will monitor your ECG continuously, however no data will be saved until
you press the
4. Press the
from left to right.
5. When the bar is fully filled, the device will analysis your data, and then show the
measurement result.
Please refer to Section 2.5 to understand the result screen.
Quick ECG
If the <Quick ECG> function is enabled, then you can start an ECG measurement very
quickly by picking up the device and hold it according to method A. This saves time and
is much easier for use. Especially for some people whose sight is not good, or when you
feel a bit abnormal during sleep and don't want to turn on the lights. To enable this
function, please refer to Section 5.8.
4.4 Oximeter
About Oximeter
The Checkme Health Monitor measures the amount of oxygen in your blood, your pulse
rate and pulse index. The oxygen saturation (SpO
percentage of full capacity.
Measuring without Cable
To start a Oximeter measurement without cable,
1. If the device is in Calendar Screen, press the Home button.
2. In the Main Screen, tap the "Pulse Oximeter" icon.
3. Insert the forefinger into the built-in SpO
button.
button to start collecting your ECG data. The countdown bar moves
) is measured and displayed as a
2
sensor as shown below.
2
13