Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
squeeze the edge of the SpO
to raise it up as shown below.
(2)
Press the right thumb on the right electrode.
(3)
Press the right middle finger on the back electrode.
(4)
Press the left electrode to the left palm.
6.
Once the device detects stable waveform, it will automatically start the
measurement. The countdown bar moves from left to right.
7.
When the bar is fully filled, the device will analysis your data, and then show the
measurement result.
Please refer to Section 2.4 to understand the result screen. Daily Check provides the
trending graph of heart rate, SpO
pressure. To view the trend, tap the
button. For details, please refer to Section 6.1.
BP Calibration
To get blood pressure readings, this device should be calibrated by a doctor with a
traditional cuff blood pressure (BP) meter. Because of individual differences, each user
must make his/her own calibration before using Daily Check to measure or track the
blood pressure. The calibration should be performed when the user is under calm status.
To calibrate with a cuff BP meter, follow the steps as below.
1.
Find a traditional cuff BP meter.
2.
Sit down and stay calm.
3.
Place the cuff on you left arm according to instructions.
4.
Pick up the Checkme monitor, press Home button to enter Main Screen.
5.
Slip your finger from right to left to enter the second page.
6.
Select the <Settings> icon, and then select <General>.
7.
Select <BP Calibration>, and then choose the right user.
8.
Ensure that the cuff and the Checkme monitor are at the same level as your heart.
Then start the blood pressure measurement from the cuff BP meter.
sensor cover, then move in upward to the left
2
and blood pressure or change in percentage of blood
2
button, then select one record, and then tap the
10
Publicité
Chapitres
Table des Matières
