Viatom Checkme Pro Manuel De L'utilisateur page 12

9. Press the
Section 4.2 to start the Daily Check measurement.
10. When the blood pressure measurement is finished, manually input the readings of
systolic pressure reading in the Checkme.
11. Repeat the calibration once again by following the above steps.
If the readings of two blood pressure measurements are very close to each other, then
the calibration is valid and finished. If the readings are not close to each other, please
wait for a few minutes, and then start the calibration again.
Warnings and Cautionary Advices
For a given user, it is suggested to make BP calibration every three months.

4.3 ECG Recorder
About ECG Recorder
The ECG recorder offers four different methods to measuring ECG. Tap the
switch between two pages.
As shown above, from left to right, there are:

Method A: Lead I, right hand to left hand

Method B: Lead II, right hand to left abdomen

Method C: Lead I, left wrist to right wrist

Method D: Lead II, right wrist to left lower abdomen
ST segment analysis is performed on selected LEAD.
Method A and B offer maximum comfort, than method C and D, but no ST segment value.
Method C and D require using external ECG cable and electrode, which is a bit more
complicated, but offers ST segment value and better measurement. No matter which
method you choose to measure ECG, please keep stable posture and stay calm during
the measurement. Movements may result in interference and incorrect readings or
analysis result.
The most suitable method or procedure depends on each individual user. Generally it is
recommended to use method A in most situations. If the ECG waveform amplitude is too
small, then use method B. Choosing method C or D when ST segment reading is needed,
or for doctor to better interpret.
Measuring without Cable
To start an ECG Recorder measurement without cable,
button on the Checkme screen, and follow the steps as described in
11
icon to