RHOSS WinPACK HE-A SE TCAEY B-S 2110 Mode D'emploi page 71

Lifting and handling instructions
IMPORTANT!
The unit was not designed to be lifted with a forklift truck.
!
DANGER!
Lifting the unit with the centre of gravity as off-centre could cause sudden and
hazardous movements.
Refer to the following instructions:
V-coiled structure
the straps tight, checking that they remain properly attached to the lifting-hook; lift the unit a few centimetres, then, only after checking the stability of the
load, carefully carry the unit to the installation site. During lifting and handling, make sure that the unit is horizontal at all times. Lower the unit carefully
drops or shifts suddenly.
Vertical coiled structure
Section II :: Installation and maintenance
Connect the chains to the relative lifting hooks. Lift the unit a few centimetres, then, only after
checking the stability of the load, carefully carry the unit to the installation site. Lower the unit
eliminate any possible risk of crushing or any other injury if the load drops or shifts suddenly.
71
!
DANGER!
Movement of the unit must be performed with care, in order to avoid damage to
the external structure and to the internal mechanical and electrical components.
Also make sure that there are no obstacles or people along the route, in order to
prevent the risk of impact, crushing or tipping the lifting and handling device.
Points for proper
positioning of the lifting
bands
TCAEBY-TCAESY 4240-4270
THAEBY-THAESY 4240-4270
TCAEBY-TCAESY 2220
THAEBY-THAESY 2220
TCAETY-TCAEQY 2170-2220
THAETY-THAEQY 2170-2220
TCAEBY-TCAESY 2150-2200
THAEBY-THAESY 2150-2200
TCAETY-TCAEQY 2150-2200
THAETY-THAEQY 2150-2200
TCAEBY-TCAESY 2110-2140
THAEBY-THAESY 2110-2140
EN