Install The Lower Intake Vent - Norcold 2118 Serie Manuel D'installation

3. Make sure the enclosure is 68.94 - 69.06 inches high x 35.94 - 36.04 inches wide x 24.00 -
24.13 inches deep.
Measure the enclosure depth [174] from the interior face of the enclosure to the
NOTICE
inside of the rear wall (See ART02478).
4. If there is more than 1/2 inch between either side of the refrigerator and the inside of the
enclosure:
- Fill the space with fi berglass (batt-type) insulation or add a baffl e to eliminate the clearance.
- The rear of the batt-type insulation must be between 18 -19 inches from the face of the
enclosure.
- Securely attach the batt-type insulation to the enclosure, so that it remains in this
position during refrigerator installation, if it becomes wet, and in windy conditions.
5. The enclosure face must be perpendicular to the enclosure shelf to provide a combustion
seal.
6. The cutout opening must be square and perpendicular to the enclosure shelf to maintain door alignment.
7. Using the following chart, decide which vents and rough opening (RO) sizes to use:
Certifi ed Vent
Upper Roof Exhaust Cap
Upper Roof Exhaust Vent
Upper Plastic Exhaust & Lower Intake

Install the Lower Intake Vent

Install the lower intake vent (See Art02479):
The lower intake vent is also the service access opening for the
NOTICE
components on the rear of the refrigerator.
Make sure the bottom of the opening of the lower intake
!
vent is even with or immediately below the fl oor level.
WARNING
This allows any leaking propane gas to escape to the
outside and not to collect at fl oor level.
- Make sure the bottom of the opening of the lower intake vent [9] is even with
or immediately below the fl oor level.
- Make sure that the opening for the lower intake vent is between 1/2 inch and
1 inch [182] from the burner side of the refrigerator enclosure.
Installation Manual 6
P/N
622293
625240
616319
625161
628073
RO Height
N/A
N/A
24 in.
24 in.
13 3/4 in.
174
ART 02478
RO Width
N/A
N/A
5 1/4 in.
5 1/4 in.
29 5/16 in.
182
9
ART 02479