Install The Lower Intake Vent - Norcold 2117X Serie Manuel D'installation

3. Make sure the enclosure is 68.94 - 69.06 inches high x 35.94 - 36.04 inches wide x 24.00 - 24.13
inches deep.
Measure the enclosure depth [174] from the interior face of the enclosure to the inside
NOTICE
of the rear wall (See art01763).
4. If there is more than 1/2 inch between either side of the refrigerator and the inside of the enclosure:
- Fill the space with fiberglass (batt-type) insulation or add a baffle to eliminate the clearance.
- The rear of the batt-type insulation must be between 18 -19 inches from the face of the
enclosure.
- Securely attach the batt-type insulation to the enclosure, so that it remains in this position
during refrigerator installation, if it becomes wet, and in windy conditions.
5. The enclosure face must be perpendicular to the enclosure shelf to provide a combustion seal.
6. The cutout opening must be square and perpendicular to the enclosure shelf to maintain door
alignment.
7. Using the following chart, decide which vents and rough opening (RO) sizes to use:
Certified Vent
Upper Roof Exhaust Cap
Upper Roof Exhaust Vent
Upper Plastic Exhaust & Lower Intake

Install the Lower Intake Vent

Install the lower intake vent (See Art01802):
The lower intake vent is also the service access
NOTICE
opening for the components on the rear of the
refrigerator.
Make sure the bottom of the opening
!
WARNING of the lower intake vent is even with or
immediately below the floor level. This
allows any leaking propane gas to escape to
the outside and not to collect at floor level.
- Make sure the bottom of the opening of the lower intake vent [9]
is even with or immediately below the floor level.
- Make sure that the opening for the lower intake vent is between
1/2 inch and 1 inch [182] from the burner side of the refrigerator
enclosure.
Installation Manual 6
P/N
622293
625240
616319
625161
628073
Art01802
RO Height
N/A
N/A
24 in.
24 in.
13 3/4 in.
9
174
Art01763
RO Width
N/A
N/A
5 1/4 in.
5 1/4 in.
29 5/16 in.
182