Connect The Water Supply Line; Ignition And Start Up - Norcold 2117X Serie Manuel D'installation

Connect the water supply line:

Install a 1/4 in. OD water supply line [43] from the water shut off valve [44] of the vehicle
to the solenoid water valve [44] at the rear of the refrigerator (See Art01822):
A brass compression nut [45], a brass sleeve, a plastic sleeve [46] ,
NOTICE
and a brass insert [47] are supplied and attached to the rear of the
refrigerator (See Art01604).
- Put the compression nut and then the sleeve onto the water supply line [43].
- For copper tubing, use the brass sleeve.
- For plastic tubing, use the plastic sleeve [46].
- For plastic tubing with .040 in. wall thickness, also use the brass insert [47].
- Flush the water supply line until the water is clear.
- Put the tubing into the adapter [48] until it is against the stop of the adapter.
- Tighten the compression nut by hand (hard finger tight).
- Using two wrenches, tighten the compression nut 1 ½ to 2 turns.
- Open the water shut off valve of the vehicle.
- Examine the connections for leaks.

Ignition and Start Up

Before ignition or start up of the refrigerator:
- Make sure the air flow in the lower intake vent, through the refrigerator coils and condenser, and out the upper exhaust vent is not
blocked or decreased.
- Make sure there are no combustible materials in or around the refrigerator.
If the gas does not ignite in 30 seconds, the gas safety valve of the refrigerator automatically closes. The controls
NOTICE
either select a different energy source or "no" "FL" appears in the center display and you will hear an alarm sound. This
means that the gas did not ignite.
If the gas does not ignite after several attempts, refer to the "Fault Codes" section of this manual.
Installation Manual 18
44
Art01822
48 47 46
43
45 43
Art01604