Electrical Setup - Festo 8106190 Notice D'utilisation

5.2 Electrical setup

•
Risk of death in case of interrupted protective earth conductor!
–
–
• Risk of death from connecting power supply units in series!
Contact voltages of > 25 V AC or > 60 V DC are not permissible.
Coming into contact with voltages of > 50 V AC or 120 V DC may be fatal.
–
• Risk of death due to electric shock!
Protect the outputs of the power supply units (output sockets/terminals) and
cables connected to them from direct contact.
–
–
Disconnect from all sources of electrical power.
• Switch off the power supply before working on the circuit.
•
Please note that electrical energy may be stored in individual components. Further
information on this issue is available in the data sheets and operating instructions
included with the components.
•
Caution!
Capacitors inside the device may still be charged even after being disconnected
from all sources of voltage.
© Festo Didactic 8106190
The PE conductor (yellow-green) must not be interrupted, either inside or
outside of the device.
The insulation of the protective conductor must never be damaged or
removed.
Do not connect voltage sources in series.
Only use cables with adequate insulation and electric strength.
Use safety sockets with fully shrouded contact points.
DANGER
WARNING
Universal Board 32
27