Optional Installation - Tripp-Lite SMART1050 Manuel De L'utilisateur

Optional Installation

These connections are optional. Your UPS will function properly without these
connections.
USB Communications
Use any USB cable to connect the USB
port of your computer to the USB port of
your UPS. Download the PowerAlert
monitoring software program appropriate
for your operating system from
tripplite.com and install it on your computer.
RS-232 Serial Communications
(Select Models Only)
Use the serial cable provided with your
UPS to connect the DB9 port of your
computer to the DB9 port of your UPS.
Download the PowerAlert UPS monitoring
software program appropriate for your
operating system from tripplite.com and
install it on your computer.
External Battery Connection
(Select Models Only)
Your UPS comes with a robust internal
battery system; external batteries
are only needed to extend runtime.
Adding external batteries will increase
recharge time as well as runtime. The
illustration shows the location of your
UPS's External Battery Connector, where
you will insert the battery pack cable.
Complete installation instructions for your
battery pack appear in the battery pack's
owner's manual. Make sure that cables
are fully inserted into their connectors.
Small sparks may result during battery
connection; this is normal. Do not
connect or disconnect battery packs
when the UPS is running on battery power.
If you connect more than one external
battery, set the Battery Charge Level
Switch to the "EXTERNAL BATTERY"
position. This will increase your UPS's
charger output so the additional
batteries charge faster.
20-08-277 932190-Book.indb 4 20-08-277 932190-Book.indb 4
(select models only)
SEE MANUAL FOR
PROPER CONNECTION
SEE MANUAL FOR
PROPER CONNECTION
SEE MANUAL FOR
PROPER CONNECTION
UPS
®
SEE MANUAL FOR
PROPER CONNECTION
SEE MANUAL FOR
PROPER CONNECTION
SEE MANUAL FOR
PROPER CONNECTION
SEE MANUAL FOR
PROPER CONNECTION
SEE MANUAL FOR
PROPER CONNECTION
SEE MANUAL FOR
PROPER CONNECTION
CAUTION! DO NOT set the
Battery Charge Level Switch
to the "EXTERNAL BATTERY"
position without an external
battery connected. There is
a risk of damaging the UPS's
internal battery system.
4
EXTERNAL
BATTERY
NORM DELAY
EXTERNAL
BATTERY
NORM DELAY
EXTERNAL
BATTERY
NORM DELAY
EXTERNAL
BATTERY
NORM DELAY
EXTERNAL
BATTERY
NORM DELAY
EXTERNAL
BATTERY
NORM DELAY
EXTERNAL
BATTERY
NORM DELAY
EXTERNAL
BATTERY
NORM DELAY
EXTERNAL
BATTERY
NORM DELAY
4/29/2021 4:40:06 PM 4/29/2021 4:40:06 PM