Optional Installation; Basic Operation - Tripp-Lite Internet Office BC Serie Guide De L'utilisateur

Optional Installation

Select models feature Tel/DSL surge suppression and USB or DB9 communication capabilities. These
connections are optional. The UPS System will function properly without these connections.
Tel/DSL Line Surge Suppression: Select UPS models can protect equipment against surges over a single phone
line. Using telephone cords, connect your wall jack to the UPS jack marked with a "
equipment to the UPS jack marked with a " " symbol. Make sure the equipment you connect to the UPS's jacks
is also protected against surges on the AC line.
USB or DB9 Communications: Select UPS models feature a communication port that can be connected to any
computer, enabling PowerAlert Software to automatically save open files and perform unattended shutdown in
the event of a power failure. Connect one end of the included communication cable to the communication port
on the side of your UPS System. Connect the other end of the included cable (featuring either a USB or DB9
connector, depending on model) to the communication port on your computer. If PowerAlert Software is
included with your UPS, insert the CD into the CD tray of your computer and follow the installation instructions.
If PowerAlert Software is not included, you can download the software FREE from Tripp Lite's website at
www.tripplite.com.

Basic Operation

1
ON/OFF/TEST
Button
6
Communication Port
(Select models only. For use with included
USB or DB9 cable.)
1
"ON/OFF/TEST" Button
• To turn the UPS on: Press and hold the ON/OFF/TEST Button for one second.* If utility power is
absent, pressing the Button will "cold-start" the UPS, i.e. turn it on and supply power from its
batteries.**
• To turn the UPS off: Press and hold the ON/OFF/TEST Button for one second.* The UPS will be turned
completely off (deactivated).
• To run a Self-Test: With your UPS plugged in and turned ON, press and hold the ON/OFF/TEST button
for three seconds.
* The alarm will beep once briefly after one second has passed. **If fully charged.
CAUTION! To perform a self-test, you must hold the ON/OFF/TEST button continuously for three
seconds; if you release the button too early, you will turn the UPS system OFF and cut power to
connected equipment loads. To ensure you hold the button for the correct length of time, do not
release the button until you hear the UPS System's audible alarm beep twice. The first beep occurs
after one second and indicates that the UPS will turn OFF if the button is released. The second beep
occurs after three seconds and indicates that the UPS will perform a self-test if the button is released.
The test will last approximately 10 seconds as the UPS switches to battery to test its load capacity and
charge. All LEDs will be lit and the UPS alarm will sound. See LED descriptions below to determine the
results of the Self-Test.
Note: You can leave connected equipment on during a self-test.
CAUTION! Do not unplug your UPS to test its batteries. This will remove safe electrical grounding
and may introduce a damaging surge into your network connections.
2 "ON/OFF" LED: This green LED lights continuously to indicate that the UPS is ON and supplying your
equipment with AC power either from a utility source or from the UPS's internal batteries. If the UPS's
alarm is sounding (4 short beeps followed by a pause), the UPS is operating from its internal batteries.
(Select Models Only)
2
3
ON/OFF LED
BATTERY LED
7
4
OVERLOAD/ Battery Backup/
CHECK Surge Protected
8
Tel/DSL Jacks Resettable Circuit
(Select models
only.)
3
" symbol. Connect your
5
Surge-Only
Protected Outlets
Outlets
Breaker