Important Safety Instructions; Ups Location Warnings; Equipment Connection Warnings - Tripp-Lite SMART1050 Manuel De L'utilisateur

Important Safety Instructions

SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that should be followed
during the installation, operation and storage of all Tripp Lite UPS
Systems. Failure to heed these warnings will void your warranty.

UPS Location Warnings

• Install your UPS indoors, away from excess moisture or heat, conductive
contaminants, dust or direct sunlight.
• For best performance, keep the indoor temperature between between 32º F
and 104º F (0º C and 40º C).
• Leave adequate space around all sides of the UPS for proper ventilation.
UPS Connection Warnings
• Connect your UPS directly to a properly grounded AC power outlet. Do not plug
the UPS into itself; this will damage the UPS.
• Do not modify the UPS's plug, and do not use an adapter that would eliminate
the UPS's ground connection.
• Do not use extension cords to connect the UPS to an AC outlet. Your warranty
will be voided if anything other than Tripp Lite surge suppressors are used to
connect your UPS to an outlet.
• If the UPS receives power from a motor-powered AC generator, the generator
must provide clean, filtered, computer-grade output.

Equipment Connection Warnings

• Do not use Tripp Lite UPS Systems for life-support applications in which
a malfunction or failure of a Tripp Lite UPS System could cause failure or
significantly alter the performance of a life-support device.
• Do not connect surge suppressors or extension cords to the output of your
UPS. This might damage the UPS and will void the surge suppressor and UPS
warranties.
Equipment Connection Warnings
• Your UPS does not require routine maintenance. Do not open your UPS for any
reason except battery replacement. There are no user-serviceable parts inside.
• Because the batteries present a risk of electrical shock and burn from high
short-circuit current, observe proper precautions. Unplug and turn off the UPS
before performing battery replacement. Use tools with insulated handles, and
replace the existing batteries with the same number and type of new batteries
(Sealed Lead-Acid). Do not open the batteries. Do not short or bridge the
battery terminals with any object. Tripp Lite offers a complete line of UPS
System Replacement Battery Cartridges (R.B.C.). Visit Tripp Lite on the Web at
tripplite.com/support/battery/index.cfm to locate the specific replacement battery
for your UPS.
20-08-277 932190-Book.indb 2 20-08-277 932190-Book.indb 2
2
4/29/2021 4:40:05 PM 4/29/2021 4:40:05 PM