Important Safety Instructions; Explanation Of Symbols - Tripp-Lite PDUMH15AT Manuel De L'utilisateur

1. Important Safety Instructions

SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that should be followed
during the installation, operation, and storage of this product. Failure
to heed these instructions and warnings will void the product warranty.

Explanation of Symbols

Caution
Protective Earth Ground Connection
Bonding Ground Connection
Electrical Shock Hazard
Remove both AC Mains Power Sources Before Servicing
• The AC mains tolerance of this equipment is : +6/-10%.
• The ATS/PDU provides convenient multiple outlets, but it DOES NOT provide surge or line
noise protection for connected equipment.
• The ATS/PDU is designed for indoor use only in a controlled environment away from excess
moisture, temperature extremes, conductive contaminants, dust or direct sunlight.
• Do not connect the ATS/PDU to an ungrounded outlet or to extension cords or adapters
that eliminate the connection to ground.
• The power requirement for each piece of equipment connected to the ATS/PDU must not
exceed the individual outlet's load rating.
• The total power requirement for equipment connected to the ATS/PDU must not exceed the
maximum load rating for the PDU.
• Do not drill into or attempt to open any part of the ATS/PDU housing. There are no
user-serviceable parts inside.
• Do not attempt to modify the ATS/PDU, including the input plugs and power cables.
• Do not attempt to use the ATS/PDU if any part becomes damaged.
• Do not attempt to mount the ATS/PDU to an insecure or unstable surface.
• Install in accordance with National Electrical Code standards ANSI/NFPA 70 and Canadian
Electrical Code, Part I, C22.1.
• Short-circuit backup protection and overcurrent protection is provided by the building
installation.
• To reduce the risk of fire, connect only to a circuit provided branch circuit overcurrent
protection in accordance with the ational Electrical Code, ANSI/NFPA 70 and the Canadian
Electrical Code, Part I, C22.1. Be sure to use maximum 20A overcurrent protection in
accordance with the plug/equipment rating for the installation.
21-02-124 933E0A.indb 2 21-02-124 933E0A.indb 2
2
3/25/2021 2:19:05 PM 3/25/2021 2:19:05 PM