Checking Installation Conditions; Installing The Dc Unit; Installing The Evaporator - Dometic Frigo DC 2500 Instructions De Montage

Installing the transport refrigeration system
7.3

Checking installation conditions

A
NOTICE!
Ensure that the vehicle complies with the minimum requirements for the instal-
lation. Correct functioning of the electrical refrigeration system cannot be guar-
anteed in the event of non-observance or alterations.
➤ Check whether the vehicle is equipped with thermal insulation with a k-value
of 0.4 W (m²/K) for the loading area.
➤ Check the requirements of the vehicle owner for the use of an electrical refrig-
eration system, such as:
– Calculation of the required refrigeration capacity
– Storage temperature of the food to be transported
– Number of door openings per hour
➤ Take suitable measures to prevent temperature changes that are too great
during loading and unloading, such as installing strip curtains on the loading
area doors or other openings.
➤ Check the output voltage of the three phase generator (14 – 15 V).
➤ Check for efficient functioning of all electrically operated vehicle compo-
nents. If errors or defects are identified, please inform workshop manage-
ment and the vehicle owner.
7.4

Installing the DC unit

!
WARNING!
Observe the original instructions of the vehicle manufacturer and the vehicle-
specific installation manual (Frigo DC VAK) for the installation of the DC unit
holder.
A
NOTICE!
Vehicles that have been equipped with an electrical refrigeration system and
possess a spare tire must be equipped with a suitable breakdown kit before
handover to the vehicle user. Inform the vehicle owner about the removal of
the spare tire.
7.5

Installing the evaporator

7.5.1 Making through-holes in the insulation
➤ Mark the position of the drill holes (position see fig. 5, page 4).
➤ Drill two holes at a slight incline in the insulation (diameter see fig. 5,
page 4).
28
Frigo DC
EN