Preparing The Installation - Dometic Waeco DC-Kit4 Instructions De Montage Et De Service

Installing and connecting the DC Kit
Observe the following safety instructions for the electrical connections:
A
NOTICE! Short circuit!
 First, disconnect the 230 V external power supply to the
caravan.
 Disconnect the earth connection to the supply battery.
 Disconnect the connection to the starter battery.
 If you have to feed cables through metal walls or other walls
with sharp edges, use ducts or tubes to prevent damage.
 Do not lay cables which are loose or bent next to electrically
conductive material (metal).
 Fasten the cables securely.
 Ensure the 12 Vg cables are especially well-protected.
 Check whether you need to fit any additional fuses.
 Do not pull on the cables.
 Do not lay the 230 V mains cable and the 12/24 V DC cable in
the same duct.
 Lay the cables so that they cannot be tripped over or dam-
aged.
Observe the following instructions when selecting the location for installing
the components:
 Make sure the cables are of the correct length.
 Choose a well-ventilated installation location near the supply battery.
7.1

Preparing the installation

➤ Disconnect the following voltage supplies in the vehicle:
– positive battery terminal
– external voltage supply
➤ Use an appropriate device to check that there is no voltage.
26
DC-Kit4
EN