Connecting The Unit To The Power Supply - DENTAURUM AIRVAC 2002 Mode D'emploi

• S crew the support to the wall lossly so that it stays still movable.
• S et the unit onto the screws and pull it downwards carefully (see picture 2).
• L ine up the support according to the drill hole in the bottom of the AIRVAC 2002 and
tide both screws (to the wall and to the bottom of the unit).
Support
1. set the unit onto the screws
Illustration 2: Mounting the AIRVAC 2002 onto the fixing screws

Caution:
Before operating the unit, check that the rawlplugs and screws are tight and the vacuum mixer
is securely mounted on the wall with the support otherwise rotations during the opperating
process could remore the unit from the wall!

4.3 Connecting the unit to the power supply

T he electricity specifications on the model plate of the unit should be the same as the mains
voltage.
• T he unit should be connected to a 230 V socket.
• The socket should be fitted with a 10 or 16 amp fuse.

Caution:
All electrical work on the socket or electricity supply should only be carried out by a qualified
electrician.
Screw head
2. and pull downwards carefully
Back plate of the unit
(viewed from the front of unit)
3. screw tidely the support with
the bottom of the unit
airvac 2002  en
EN
20