Environmental Protection; Installation; Start-Up; Initial Start-Up - Häfele LockerLock LL 200 Mode D'emploi

3.3 Environmental
protection

4. Installation

5. Start-up

5.1 Initial start-up

16
Do not touch
Components with this marking could be damaged by touching.
Lead
The circuit board does not contain lead.
NOTE
Risk to the environment due to improper handling of
environmentally hazardous substances!
Improper handling of environmentally hazardous substances, particularly
improper disposal, can cause significant damage to the environment.
> Always follow the notes below for handling environmentally
hazardous substances and their disposal.
> If environmentally hazardous substances are accidentally released
into the environment, immediately take appropriate action. When in
doubt, notify the appropriate local authority of the damage and
check for appropriate measures to be taken.
The following environmentally hazardous substances are used:
Batteries
Batteries contain toxic heavy metals. They are subject to special waste treatment
and must be handed into municipal collection points or disposed of by a specialist
company.
Electric and electronic components
Electric and electronic components may contain toxic materials. These components
must be collected separately and be deposited at municipal collection points or
disposed of by a specialist company.
The installation instructions are a separate document and are enclosed with the
product. They are exclusively intended for:
• The operator
• the installation and start-up personnel
The product is supplied in so-called simple operation mode for stand-alone
operation (SA). These instructions only describe how to start up in this operation
mode.
• Contact the manufacturer for other operation modes.
• The "Stand-Alone" operation mode will be permanently shut off once the product
is configured for the first time using the Dialock MDU. After that, reactivating this
operation mode is only possible after a reset.
The programming key and the erasing key are taught in for initial start-up.
These work operations only need to be carried out during initial start-up.