Fork; Tyres - Wayscral EVERYWAY E-250 Notice D'utilisation

1: Tightening the handlebar on the stem
Tilt the handlebars to your preferred level and then tighten screws 1 and 2.
2: adjustment of handlebar/wheel alignment
Loosen screw 3, adjust the position of the handlebars in relation to the wheel axis and then tighten
screw 3 again
3: Adjusting the inclination of the stem
Loosen screws 4 and 5, adjust the tilt of the stem to your convenience and then retighten the screws.
3.

Fork

Your fork is equipped with a preload adjustment, turn the knobs clockwise to lightly harden your
suspension.
III.

Tyres

Check tyre pressures regularly. Riding with insufficiently inflated or overinflated tyres can adversely
affect performance, cause premature wear, reduce battery life or increase the risk of accident.
If there is significant wear or there is a visible groove on one of the tyres, replace it before using the
bicycle. The manufacturer provides a pressure range on the side of the wheel rim and in the following
table. The pressure should be adapted to the weight of the user.
Model
EVERYWAY E250
Method for determining the correct adjustment of the quick release mechanisms (wheel and seat
clamp)
The quick release systems are designed to be operated by hand. Never use tools to block or unblock
the mechanism to avoid damaging it.
To adjust the clamping force of the wheel axle, you must use the adjusting nut and not the quick release
lever. If the lever can be operated with minimal manual pressure, it means that it is not sufficiently
Bike size Size of inner tubes
28"
700 x 45
Tyre size
700 x 45
41
Pressure
PSI Bar
3.5 – 5.5
50 - 80