SIGFOX PULSE - Mode d'emploi / User guide version V1.5.1
To optimise fixing to a tube or mast, we recommend removing the
DIN-Rail locking/unlocking lever.
To remove it, pull down on the lever until the locking lugs are clear,
then remove the lever.
2.8.2 Fixing with screws
The SIGFOX PULSE is supplied with 2 CBLZ 2.2 x 19mm screws and 2 SX4 plugs. Use these or equivalent products to fix your product to a flat
surface.
You have a choice of two positions: flat or on its edge.
•
The edge position lets you distance the product from its support and therefore plays a part in better propagation of radio waves.
•
If you opt for the flat position, make sure you remove the DIN-Rail locking/unlocking lever as explained above.
Flat mounting
Screw holes for flat fixing
Screw holes for edge fixing
Edge mounting
Lugs
Clear part
Page
37
of 41