Preparing To Steam-Clean Floors - Dirt Devil Aqua Clean M319 Mode D'emploi

M319.book Seite 25 Donnerstag, 28. November 2013 2:39 14
3 Preparing for use

3.4 Preparing to steam-clean floors

A
click!
6
A
7
A
WARNING! Danger of scalding! WARNING! Danger of scalding!
8
A
9
A
10
 Attaching extension tubes and floor nozzle:
B
1. Attach the upper extension tube as shown to the steam pistol (Fig. 6/
A). You will feel and hear it snap into place.
2. Attach the middle extension tube to the extension tube just mounted as
shown (Fig. 6/B). You will feel and hear it snap into place.
click!
3. Attach the lower extension tube to the extension tube just mounted as
B
shown (Fig. 7/A). You will feel and hear it snap into place.
4. Now attach the floor nozzle onto the extension tube just attached
(Fig. 7/B). You will feel and hear the connecting piece of the floor nozzle
snap into place.
To steam-clean insensitive stone floors, tiles and the like which

B
have stubborn stains (Fig. 8/B):
1. Release the steam base with collar brush from the floor nozzle by push-
ing down the foot pedal of the floor nozzle (Fig. 8/A).
2. Remove the steam base with collar brush up out of the floor nozzle.
Hot steam! Hot steam!
ATTENTION:
Not all floors suited to steam cleaning would also withstand the powerful
bristles of the collar brush. Only use the combination of hot steam and
collar brush on completely insensitive floors. If you are unsure, enquire
with the manufacturer of your floor surface. Then test to see whether the
floor can withstand this treatment without damage on an unnoticeable
part of the floor.
 To steam-clean smooth, lightly soiled stone floors, tiles and the
B
like (Fig. 9/B):
1. Release the carpet glider base from the floor nozzle (Fig. 9/A).
2. If you have not done so already, attach a clean micro-fibre cleaning
cloth to the floor nozzle (Fig. 9/B).
B  To refresh carpets and the like (Fig. 10/B):
1. If you have not done so already, attach a clean micro-fibre cleaning
cloth to the floor nozzle (Fig. 9/B).
2. If you have not done so already, attach the carpet glider base back on
to the floor nozzle (Fig. 10/A).
25