Bergstrom FLEX POWER II Mode D'emploi page 29

Masquer les pouces Voir aussi pour FLEX POWER II:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

FLEX POWER II
PIPE AND CABLE ASSEMBLY
Secure the most suitable coupling (90º or
1
straight with service port) in 5/8" pipe and
connect to the power unit.
Connect the evaporator extension cable
2
and run to the evaporator unit alongside 5/8"
pipe. If Ø35 boreholes are to be made, install
the supplied bushing in order to access the
evaporator unit.
Caution: pass through along with the original
pipes or cables, avoiding any sharp areas and
constrictions, and secure with cable ties.
2
2
1
2
1
2
29
EN
2

Publicité

Table des Matières
loading

Table des Matières