Alarm Function - AEG MRC 4126 P Mode D'emploi

English
50
Volume
The desired volume can be sent using the VOLUME regulator (18).
Setting of the Clock (24 h)
1. Set the adjustment switch SETTING (20) to the position "TIME".
2. Turn the rotating bezel to the right to set the hours.
3. Turn the rotating bezel to the left to adjust the minutes.
4. Then, set the adjustment switch SETTING to "TIME" or "RUN". The colon in the
display is lit up.
NOTE:
The time of the projector needs to be set up separately. To adjust the time of day, please
proceed as described in the section "Projection".
Switch-off
The device is switched off if the function switch (19) is in the "OFF" position.

Alarm function

Setting of the Alarm (24 h)
1. Set the adjustment switch SETTING (20) to the position "ALM".
2. Turn the rotating bezel to the right to set the hours.
3. Turn the rotating bezel to the left to adjust the minutes .
4. Then, set the adjustment switch SETTING to "RUN". The colon in the display is lit up.
Radio alarm
Once the alarm times are set and a radio station has been selected, shift the function
selector (19) to "AUTO". A dot lights up in the display next to "AUTO" (7).
NOTE:
As soon as the alarm time is reached, the radio is switched on. The selected radio station
plays at the set volume.
Buzzer alarm
• If you would not like to be woken up by the radio, turn the VOLUME control (18) to the
"BUZZ" position until it locks in place.
• Instead of the radio, the buzzer goes off when the alarm time is reached.