Automatic Shutdown - Bosch GRL 500 H Consignes De Fonctionnement/Sécurité

The new state [Sleep mode
function activated - SLP On] and
the sleep mode indicator 44 will be
shown on the display for
approximately 3 s.
Automatic Shutdown
The measuring tool and the laser receiver
switch off automatically under certain
conditions (see "Switching Off", page 20 for
outcome):
– The measuring tool does not receive any
commands for more than 2.5 h.
– The buttons on the laser receiver are not
pressed for more than 2.5 h.
– The measuring tool is outside of the self-
leveling range for more than 2.5 h.
– The measuring tool is not switched on
again within 2 h after 30 minute activated
sleep mode has elapsed
– The anti-drift system is triggered for more
than 2.5 h.
Switching on the unit outside
operating temperature range causes
an audio signal to sound and the out
of temperature-range indicator 34 to
flash for approx. 5s and then will
shutdown automatically.
After automatic shutdown:
– If applicable, wait until the measuring tool
and the laser receiver are back in the
operating temperature range.
– If required, reposition the measuring tool
and switch it on again.
RTC (Real Time Clock) Battery
The calibration interval indicator 35
will not flash if the RTC battery is
weak. The indicator will only flash
when both RTC and Li-Ion battery
are fully drained. The calibration
interval will no longer be monitored.
– Contact an authorized service agent for
Bosch power tools.
Theft Alarm System
The system consisting of measuring tool and
laser receiver has two security mechanisms
to help prevent theft:
– The measuring tool can only be operated
using the laser receiver; there is no
control panel on the measuring tool.
2610A16816.indd 21
– Both audible and visual indications are
given on the measuring tool and on the
laser receiver when the measuring tool is
moved away from the reference point.
The default setting in the delivery condition is
[Theft alarm system activated].
Application
Measuring tool
switched on.
or
Measuring tool
in sleep mode.
/
Measuring tool
switched off.
Laser receiver
switched off
and not in the
charging/storage
station 6.
If the theft alarm system is activated and the
/ measuring tool moves away from the current
location for more than 5 s, the alarm system
will be triggered:
– An audio signal is emitted on the
measuring tool and on the laser receiver.
The A-weighted sound pressure level of
the audio signal is up to 110 dB(A) and
cannot be adjusted using the volume
setting of the normal audio signal.
Do not hold the laser receiver close to
your ear! The loud audio signal can cause
hearing defects.
– All operating functions are locked.
– The theft alarm LED 4 on the
measuring tool flashes quickly.
– The theft alarm indicator 36 on the
laser receiver flashes.
– To switch off the triggered alarm,
press the theft alarm button 22.
The audio signal is switched off.
All operating functions are
unlocked.
The theft alarm system is activated
again.
Deactivating the Theft Alarm System
– Press the theft alarm button 22
while the measuring tool is
switched on.
-21-
Security mechanism
Alarm system activated
Theft alarm
indicator 36 lights
up continuously
Theft alarm LED 4
flashes slowly on
the measuring tool
Alarm system deactivated
Theft alarm indicator 36 is
not displayed
Theft alarm LED 4
does not light up on the
measuring tool
/
/
/
/
11/13/15 1:12 PM