Switching Off - Bosch GRL 500 H Consignes De Fonctionnement/Sécurité

Operation
Note: In their delivery condition, the
measuring tool and laser receiver are paired,
which means the laser receiver can perform
the remote control functions.
To save energy, only switch the measuring
tool and the laser receiver on when you are
using them.
Switching On
– To switch on the measuring tool,
slide the laser receiver into the
charging/storage station 6 and then
press the On/Off button 17.
or
– Slide the laser receiver into the
charging/storage station 6 and
remove it from the charging/
storage station again. To switch on
the measuring tool, you then have
to press the On/Off button 17 within
30 minutes.
Outcome:
– All display indicators light up briefly.
– Automatic leveling starts (see "Automatic
Leveling", page 22).
– The anti-drift system is activated 30 s
after switching-on.
The measuring tool then emits the laser
beam 7 (GRL 500 H)
or the laser beam 7 and the plumb beam 1
(GRL 500 HV).
Switching Off
– Press the On/Off button 17 for
approx. 2 s.
Outcome:
– The rotation stops and the laser beam is
switched off.
– All display indicators and the display
illumination are switched off.
Note: If the laser receiver and the rotational
laser level are switched off, the laser receiver
first has to be docked back in the charging/
storage station 6 to switch the tool on.
Sleep Mode
The laser receiver can be used to put the
measuring tool into sleep mode for maximum
of 2 hours.
Note: If the laser receiver and the rotational
laser level are in sleep mode for more than
2610A16816.indd 20
2.5 h total, both are automatically switched
off. The laser receiver first has to be docked
back in the charging/storage station 6 to
switch the tool on.
– To switch on sleep mode, press the
sleep mode button 21.
In sleep mode, the sleep mode
indicator 44 on the laser receiver
lights up and the theft alarm
indicator
the theft alarm system is activated.
The theft alarm LED 4 on the
measuring tool flashes if the theft
alarm system is activated.
All other indicators and the laser beam are
switched off. The anti-drift system remains
activated.
– To end sleep mode, press the
sleep mode button 21 again.
Sleep mode is automatically switched on
/
if the laser beam does not run through the
reception area 26 for more than 30 minutes
or the buttons on the laser receiver are not
pressed for more than 30 minutes.
Note: If the laser receiver and the rotational
laser level are in sleep mode for more than
2 h, both are automatically switched off. The
laser receiver first has to be docked back in
the charging/storage station 6 to switch the
tool on.
The measuring tool always starts with the
sleep mode function activated.
– To deactivate the sleep mode
function, simultaneously press the
On/Off button 17 and the sleep
mode button 21 for approx. 2 s
while the measuring tool is
switched on.
The new state [Sleep mode
function deactivated - SLP OFF]
and the sleep mode indicator 44
will be shown on the display for
approx. 3 s.
This setting is not saved when the
tool is switched off.
/
– To activate the sleep mode
function, simultaneously press the
On/Off button 17 and the sleep
mode button 21 for approx. 2 s
while the measuring tool is
switched on.
-20-
/
36 also lights up if
/
/
/
11/13/15 1:12 PM